10/100/1000 Copper to Optical Conversion nTAP

Observer TAPs - Conversion


Place a 10/100/100 Copper to Optical Conversion nTAP between two devices of interest on a 100 Mbps or 1000 Mbps copper link. Then attach either a copper or optical monitoring device to the nTAP. Only one analyzer connection can be utilized at a time. To successfully analyze the full-duplex link, the monitoring device must be equipped with a dual-receive capture card.

Technical Specifications



Depth 7.66 in / 19.46 cm
Width (faceplate front) 5.85 in / 14.86 cm
Width (back) 4.55 in / 11.56 cm
Height (faceplate) 1.10 in / 2.79 cm


Power Requirements

Specification Measurement/Value
AC Input 90 V to 264 V, 47 Hz to 63 Hz
Operational Voltage 5 V (+10% to -5%, ≤ 100 mV ripple)
Operational Current Typical: ≤ 1.8 amps Max: ≤ 2.8 amps
Power Dissipation Typical: 8 W Max: 14 W


Supported Media

Interface Media
Link A/Link B (Link under test) RJ45
Copper Analyzer Interface RJ45
SFP Conversion Analyzer Interface SX
850 nm, 1000BaseSX Multimode LC connector
1310 nm 1000BaseLX Multimode or Single-mode LC connector


Environmental Requirements

Specification Operational Range Storage Range
Temperature Range 32° to 120°F / 0° to 55 °C 32° - 167°F / 0° - 75°C
Humidity 35-85% (non-condensating)


Regulatory Compliance

Specification Certification
Emissions FCC Part 15 Class B
CE Mark EN61000-3-2, EN55024, EN55022A

Alle Observer TAPs - Aggregation - Produkte im Überblick

10/100/1000 Aggregator nTAP

Transfer network traffic from a full-duplex copper link to a copper analysis or security device in a single stream.

zum Produkt >> 

10/100/1000 Aggregator Conversion nTAP

Place an Aggregator Conversion nTAP between two devices of interest on a 10 Mbps, 100 Mbps or 1000 Mbps copper link.

zum Produkt >>

Optical to Copper nTAP

Optical to Copper Aggregator nTAP

Place an Optical to Copper nTAP between two devices of interest on a 1Gbps full-duplex optical link.

zum Produkt >>

+49 89 904 10 11 12Telefon Icon
info@eudisa.comE-Mail Icon